Laboratory Water Baths Laboratory Water Baths Circulators offered by Plasto Crafts have been carefully designed to meet the exacting requirements of temperature control in a variety of applications such as absorbance measurements in Spectrophotometry, Viscosity measurements and some Biomedical test procedures etc.
The Laboratory Water Baths circulators incorporate a pressure pump which makes it possible to circulate bath fluid held at constant temperature through an external jacketed system and hold the system at any temperature between -40oC to + 150oC depending upon the model chosen.
All the Laboratory Water Baths models are bench-mounting type, simple to operate and with a precise temperature control. The following features are shared by all the models shown in this brochure.
- Temperature control accuracy of + 0.1 oC microprocessor PID controller.
- Digital indication of the preset and actual temperature.
- Bath chamber and its cover are made of Stainless Steel.
- Drain-tap to drain out the bath liquid.
- Over temperature protection.
- Castors for floor mounting on request at extra cost.
Specifications
Heating Bath Circulator Model CTB-100 Microprocessor PID Control
|
Operating Temperature Range
|
Ambient + 5oC to 95oC
|
|
Temperature Readout
|
Digital
|
|
Temp. Control Accuracy
|
+ 0.1oC
|
|
Pump Flow Rate
|
12 Lit / Min
|
|
Bath Opening/Depth
|
(220 x 215 x185) mm
|
|
Bath Volume
|
12 Lit.
|
|
Temp. Control Mode
|
Microprocessor PID
|
|
Heater Power
|
1000W
|
|
Overall Dimensions (L x W x H)
|
(400 x 375 x 465) mm.
|
Models is available in 4 litre capacity also.
Some Applications
- Spectrophotometry
- Viscometry
- Thermogravimetry
- Some Bio-Medical Test Procedures
- Petroleum Industry
|
Phone : 91-22-28509938/9799/65174181
Fax : 91-22-28509799
